RE240S6-1NCPP
Bradford White 40 Gallon
Electric
Water Heater
Bradford White upright electric tanks are a clean, straightforward option when you want a simple replacement with no venting system and fewer combustion variables.
RE240S6-1NCPP-458 is a 40-gallon electric tank option that suits smaller households or moderate daily demand where the goal is steady, predictable hot water in a simple mechanical package.
Before we install it, we confirm electrical supply and service access, and we make sure the relief drainage strategy can be done correctly. We also verify physical fit (height and diameter) so the replacement isn’t forced into a tight space that compromises serviceability.
We confirm sizing and pricing on site – no pressure, no upsells.
Installed in Ottawa and surrounding areas by Peak Comfort HVAC
Specs for the RE240S6-1NCPP
- Spec sheet reference model: RE240S6
- System type: Storage tank water heater
- Fuel / energy source: Electric
- Venting: None (electric)
- Nominal capacity: 40 USG (151 L)
- Input / heating capacity: 3000W
- Efficiency (UEF): 0.91
- Recovery: Typical with 3000W non-simultaneous is 21 GPH at 90°F rise; varies with element wattage and wiring configuration
- First hour rating: 48 gal
- Tank diameter: 20 in (508 mm) jacket diameter
- Height (installation / overall): 47 3/16 in (1199 mm) floor to top of heater
- Water connections: 3/4" NPT
- Approx. shipping weight: 123 lb (56 kg)
- Warranty: 6 or 10-year limited tank warranties / 6-year limited warranty on component parts
Technical documents
Key features of the RE family
What it is:
- Upright residential electric storage tank water heater
- Screw-in style immersed elements for direct heat transfer
- Designed to meet NAECA requirements
Comfort & operation
- Fully automatic controls with thermostat and high-limit energy cut-off
- Non-simultaneous or simultaneous operation options depending on configuration
- Recovery behavior varies by element wattage and wiring
Build & serviceability
- Vitraglas lining with Microban antimicrobial protection (tank lining surface)
- Hydrojet total performance system for sediment reduction and improved delivery
- Protective anode rod for corrosion resistance
Install + ownership notes
- No venting system required (electrical + plumbing fit are the key constraints)
- Expansion control may be needed in closed systems (site-dependent)
- Clean service access and safe T&P discharge routing are non-negotiable
Want to see if this tank is the right fit?
If this PV is the right size, we’ll confirm venting, gas-side constraints, and service access before we install.
Get in Touch
Office Address:
275 Montfort St, Ottawa
ON K1L 5N8
Servicing: Ottawa, Orleans, Nepean, And the surrounding areas
Phone:
E-Mail:
info@peakcomfort.ca
Quick Contact
Email: info@peakcomfort.ca
© Peak Comfort HVAC Inc. All Rights Reserved.